Having had solar panels on the roof of my home for the past several years has proven to be a worthwhile endeavor. With my particular installation I went with Enphase microinverters which I am pleased with. One of the things I like is the Enphase app on your phone. This allows you to look at the performance of each solar panel on your solar photovoltaic system. By the way, if you are interested in the details of my solar panel installation, click here.
A while back I noticed one solar panel was not performing as well as the others. Interestingly, it was putting out about two thirds the daily wattage of the other panels. So my first question was there a problem in the Enphase microinverter or in the solar panel itself. So I swapped solar panels between the defective one and a good solar panel. Doing a solar panel swap showed me that the problem was in fact with the solar panel.
I
In doing some internet searches as to why I had reduced output, I learned that solar panels have bypass diodes and that if one fails, it will cause reduced output on a solar panel. I also learned that in a typical 60 cell solar panel there are three bypass diodes which are located in the solar panel’s junction box. Below is a diagram of a typical solar panel:
The purpose of bypass diodes in solar panels is to protect solar panels from overheating when partial shading occurs. When partial shading happens on let’s say one of the three strings in the panel above, the output in that string drops to zero volts. Without bypass diodes, and if there is partial shading, the individual cells will actually start consuming electricity from the other cells and also cause excessive heating, which can cause the solar panel to catch on fire. However in my case, one of the diodes in the solar panel shorted out and was completely cutting off one third of the 60 cells in the solar panel.
Leave a Reply