How To DIY A Cantenna For Your WiFi Network

Using this wire as a measuring guide, cut the wire that is soldered to the N connector to the 1.25 inch length.

Attach the 4″ vent clamp snugly to the end. This forms the tube into a circle. Then mark the aluminum along the outside of the clamp.

Secure the plate with duct tape. Then place the 4 inch clamp over the duct tape to secure it.

Cut 4 vertical slots in the 4 inch end of the 4″ to 6″ adapter. Slide the dryer vent tube INSIDE the adapter, and secure it with another 4 inch clamp.