Extend Your Wireless Network with a DIY 2.4 GHZ WiFi Cantenna

Snap the dryer vent tube together, and make sure the edges are flush at the seam. Measure 13.5 inches from this end, and cut the tube to this length.

DIY Cantenna to extend a WiFi signal

Dryer vent tube end snapped together.

Solder aprox. 1 1/2 in. of 14 ga. wire to the N Connector. I connect a spare N male to dissipate heat from soldering.

DIY Cantenna for extending WiFi signal

Solder wire to Type-N connector

Measure 1.75 inches from the edge of the vent.

DIY Cantenna for extending a WiFi Signal

Measure 1.75 inches from end